It's simple. You need good IP3 figures to enable a good dynamic range
figure, but they have to be the result of excellent design and
implementation. In order to assure that this is the case, it's better to
look at both numbers.
It is correct that the IP3 can be improved by placing an attenuator in the
front end. It's normally linear. If you attenuate the front end by 10 dB,
the IP3 goes up by 10 dB.
The interesting question to be asked is "how much IP3 or dynamic range do we
As far as I know, nobody has ever answered this, except to say "as much as
you can get." Just as good of an answer would be "it depends."
The problem becomes a diminishing return on your investment. At some point,
trying to get another 3 to 6 dB can cost more money than the rest of the
And that is all just part of the answer.
The IP3 will also depend on how it is measured.
If you want to compare numbers on two different rigs, you have to assure
both numbers were measured exactly the same way.
Altogether, this is what has led me to the point that I take all measured
numbers with a grain of salt and prefer to try all the rigs, comparing them
to several other rigs that I know well - under all kinds of adverse
conditions. Then I have a feeling about the performance of the rig.
Being a member of one of Europe's largest contest clubs, I get the
opportunity to eventually try everything that comes on the market with
excellent antennas at sites which are remote as well as located in an
I know this wasn't a short, specific answer to your question but I don't
think there is such an answer.
From: email@example.com [mailto:firstname.lastname@example.org]
On Behalf Of KD7EFQ@aol.com
Sent: Thursday, November 25, 2004 4:46 AM
Subject: [TenTec] IP3 controversy
Hello all, I have been reading a few reviews and asking questions about this
"Third order intercept" number that is all the rave these days. I have a
understanding of what this is, but some controversy has arisen as to how
important this really is.
Rob Sherwood of Sherwood Engineering only lists dynamic range numbers on his
Dayton 2004 comparison chart. I ran into him on the air and asked him why he
does not show IP3?
He responded that anybody can raise there IP3 number simply by turning on
their attenuator on any rig and so it wasn't that important to him. I just
the same statement on the latest review of the IC756PROII where the VK
said anyone can raise their IP3 by inserting an attenuator in front of the
I vaguely remember reading Doug Smith's Article on receiver performance,
where he stated that dynamic range numbers alone did not tell the whole
receiver performance, and you had to consider IP3 numbers to get an accurate
picture. Since he helped develop Orion, I assume he knows what he's talking
Bottom line, Who's right, and Just how important is IP3?
73, Todd - KT0DD - email@example.com
"The race is over...THE RATS WON !"
TenTec mailing list
TenTec mailing list