I don't know the way the Acom is connected,
However, there are a couple of controls that will lengthen the delay between
the amplifier action and the start/end of the signal.
These are the "EXT T/R Delay 1" and 2 in the TX menu and the "CW QSK Delay"
in the CW menu.
The 1st is for Non QSK set up, the second is for a QSK set up.
Read up on those two and see if they will help solve the problem.
thanks
Rich
K5SF
From: n1eu@netscape.net (Barry N1EU)
To: tentec@contesting.com, Orion@contesting.com
Subject: RE: [Orion] Firmware upgrade and CW/ACOM2000A issue again
Date: Sat, 04 Dec 2004 07:53:42 -0500
"Sergei Kulyov" <ua3ap@smtp.ru> wrote:
>Does anybody got an issue while in CW keying ACOM2000 after
>upgrade to 1.372? My ACOM immediatly fails to transmitt
>with "ARC fault" alarm althouth I'm using it in QSK mode.
Sergei, my Orion seems to key my Acom 2000A perfectly with v1.372. Sorry
to hear of your troubles.
73,
Barry N1EU
__________________________________________________________________
Switch to Netscape Internet Service.
As low as $9.95 a month -- Sign up today at
http://isp.netscape.com/register
Netscape. Just the Net You Need.
New! Netscape Toolbar for Internet Explorer
Search from anywhere on the Web and block those annoying pop-ups.
Download now at http://channels.netscape.com/ns/search/install.jsp
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|