[TenTec] Adding the 2.8khz filters to Omni VI

["n4lq" <n4lq@iglou.com>]

1. With rig facing you, turn it over.
2. Remove bottom cover.
3. remove bottom shield.
4. On the left rear you have 2 optional filter slots. Don't use those.
5. There is a filter on the far left (non optional). This is your 2.4khz.
6. Remove this 2.4khz and insert the 2.8khz filer. This completes the 9 
mhz filter installation.

7. The filter board on the right is your 6.3mhz IF. It has 4 slots.
8. The far rear one is the non-optional 2.4khz filter.
9. Replace it with your 2.8khz filter.
10 You are done. Don't mess with any jumpers.

steve N4lq