Folks,
Sorry to say the chart formatting was lost in transition. Here it is,
hopefully readable.
BTW, I put the appropriate offset channels in memory to make sure I
end up in the right place, per the ARRL Web page:
This chart from the NTIA suggests appropriate tuning frequencies for
each center-channel frequency:
Channel Center Amateur Tuning Frequency
(USB only)
5332 kHz 5330.5 kHz
5348 kHz 5346.5 kHz
5368 kHz 5366.5 kHz
5373 kHz 5371.5 kHz
5405 kHz (common US/UK) 5403.5 kHz
In case anyone hasn't seen the chart.
73, Joel, W1ZR
Jim Bull wrote:
Bob,
On my two Paragon's, the MARS/CAP/60M mod is accomplished by
cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
and resetting the processor. The jumper is located directly below the
9 volt memory battery.
NOW, if someone can tell me what/where the mod is on the Paragon II,
I would appreciate it VERY much.
Jim/Ke3nK
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Robert Lutz wrote:
Does anyone have the modification to make the Paragon transmit out of
band
tnx 73 Bob
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|