TenTec
[Top] [All Lists]

Re: [TenTec] mystery Ten-Tec Omni

To: "\"Scott Sheppard\"" <scottsheppard@videotron.ca>
Subject: Re: [TenTec] mystery Ten-Tec Omni
From: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 21 Feb 2005 19:59:53 -0500
List-post: <mailto:tentec@contesting.com>
Hi, Scott--

To have 18 MHz capability, you will need to add a different rig.  Because 
that Omni (whether B or C) uses a 9 MHz intermediate frequency, because the 
second harmonic of that is 18 MHz, because various and sundry mixer products 
produce spurs and other unwanted output in those Omni rigs, they are not 
suitable for use on that band.

73, Mike N4NT

----- Original Message ----- 
From: "Scott Sheppard" <scottsheppard@videotron.ca>
To: <tentec@contesting.com>
Sent: Sunday, February 20, 2005 7:40 PM
Subject: [TenTec] mystery Ten-Tec Omni


First off, thanks to all those who replied with help on my dead TX. It is 
now fixed after replacing numerous components it turned out to be a broken 
wire input to the Low Level Driver. What a great way to get to know a 
radio--spend a few hours taking it apart!

I do, however, have some more questions. I have read many posts but am still 
unclear on a few items:

1) I know the Omni A, D , C, series B etc etc has been beaten to death and I 
think I have a good handle on it. However, I think "my rig is different" 
because of the following:

-I purchased it used as an Omni D Ser B.
-the ser number reads 545-0622
-the back heat sink reads "HF Tran. 545 Series B, Ten-Tec etc...

-the front panel has all bands 160 thru 10 as well as all WARC bands (Not 
aux pos's) dial positions.
-3 way Crystal filter switch w/filters
-3 way audio switch
-Notch filter, Noise Blanker dials, REF Atten etc etc.
-the manual I rec'd with the rig and matching model 255 pwr supply refer to 
diagrams, etc with Ser C written on it.

To all external appearance it looks like a ser C ??

Is it possible some parts were mixed and matched? (the radio orig came from 
Tenessee) or is what I have a Ser B with all the options? I thought the Ser 
B was a 546, and even then only had Aux pos for WARC. If not a ser c what 
else would it have?

All that said, to have 18Mhz, what do I require, Just a x-tal or an entire 
kit?

A long winded multi question post I realize, but I am trying to get up to 
speed as quickly as I can.

Kind regards,

Scott  VA3ZW

PS: Moderator, how do I join this group? 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>