Re: [TenTec] Ten Tec Vee Beam?

[Ken Brown <ken.d.brown@verizon.net>]

>The quarter wave termination is high impedance at the end where it joins the
>Vee element, end and low impedance where it is staked to ground by ground
>rod.
>  
>
Or if it is not grounded at the far end, and is used in place of a good 
ground to "simulate" a ground for the termination resistor, then it is 
low impedance at the resistor and high impedance at the far end. This 
would probably require some separation from ground along it's length, 
especially at the open end, to work this way.


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec