Jim: If you are on the Oscillator-Mixer board, there is indeed a typo (in
my manual). Paragraph
3, page 3-7, I set the bandswitch to 14 mhz & adjusted R-29 to set display
to 14.0000. A drop
of De-Oxit on R-29, working R-29 back & forth a few times, prior to this
adjustment stopped my
Corsair II's frequency hop-skip-jump'in around. This was after a PTO
rebuild had helped the freq
excursions very little.
Luck with it.
"73" Dub
At 02:35 PM 3/5/2005, you wrote:
>No Mike, not varible that is. There is a typo and R29 does adjust..
>----- Original Message -----
>From: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
>To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>Sent: Saturday, March 05, 2005 11:35 AM
>Subject: Re: [TenTec] Corsair II
>
>
> > is there a C3?
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
--
J. W. (Dub) Thornton K5DUB
Minco, OK.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|