TenTec
[Top] [All Lists]

Re: [TenTec] Orion Power Connector orientation

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion Power Connector orientation
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
Reply-to: Steve Baron - KB3MM <SteveBaron@StarLinX.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 23 Mar 2005 20:03:50 -0000
List-post: <mailto:tentec@contesting.com>
IMHO, many of the 'drawings' in the manual are horribly hard to read.

----- Original Message ----- 
From: "A. Sewell" <n5na@att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, March 23, 2005 19:55
Subject: Re: [TenTec] Orion Power Connector orientation


> Wow, I couldn't even see the connector orientation in my printed
> manual.  Zooming in on the PDF does show it is oriented the opposite of
> the way my Orion is oriented.
>
> So....looks like the drawing needs to be fixed.  It would be nice if the
> manual included a close up of the power connector.
>
> 73,
>
> Alan  N5NA
>
> Grant Youngman wrote:
>
> >Either my Orion is not assembled correctly, meaning the chassis
> >connector was installed upside down, or the diagram as shown on page
> >25 of the Rev. 3 manual is incorrect.  It shows the flat sides of the
> >connector closest to the cabinet edge when in fact they are oriented the
> >opposite direction (in my Orion at least).  + power is on the top as
shown.
> >
> >"Trust, but verify" is the operative phrase here :-)
> >
> >-------------------------------
> >Grant Youngman /NQ5T
> >http://www.globeking.com
> >
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>