TenTec
[Top] [All Lists]

[TenTec] Caution: some old Ten-Tec supplies are hazardous to your rigs

To: "Ten-Tec Reflector" <tentec@contesting.com>
Subject: [TenTec] Caution: some old Ten-Tec supplies are hazardous to your rigs
From: "Mike Hyder -N4NT-" <mike.hyder.n4nt@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 11 May 2005 09:42:32 -0400
List-post: <mailto:tentec@contesting.com>
The Ten-Tec supplies 252 and 262 did not incorporate a "crowbar" circuit to 
protect the rig from a fault which would supply too great a voltage to the 
rig.  This can happen if the pass transistor shorts out and the power supply 
output rises to 24 or 25 volts.

Ten-Tec later made a small circuit board available as an inexpensive option. 
This was called the OVP, overvoltage protection circuit.  The small board 
was about 1 x 2 inches and holds a fuse, an SCR and a zener diode as I 
recall.  The instructions that came with it said to mount it inside the back 
panel of the supply and to cut the large red wire before it went to the 
output leads or connector, hooking the two ends created by the cutting to 
two solder points on the OVP circuit board.

My suggestion is that if you have one of these supplies you check to make 
sure it has that little board inside.  It is more important than you might 
think.

73, Mike N4NT

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Caution: some old Ten-Tec supplies are hazardous to your rigs, Mike Hyder -N4NT- <=