Sorry Folks:
I've been out of town and away from the computer and radio for a few days.
I'll look into some suggestions I've received and then decide just how to
proceed. Thanks for the offers and suggestions. I hang on to your e-mails
and info.
Thanks again.
73
Bob, K4TAX
----- Original Message -----
From: "Ken Simpson W8EK" <W8EK@speakeasy.net>
To: <RMcGraw@Blomand.net>
Cc: <W8EK@speakeasy.net>
Sent: Saturday, May 21, 2005 8:40 AM
Subject: RE: Omni Manual
I did not get any answer to this.
Maybe it got lost.
Thanks.
73,
Ken, W8EK
-----Original Message-----
From: Ken Simpson, W8EK [mailto:W8EK@speakeasy.net]
Sent: Friday, May 20, 2005 8:13 AM
To: 'RMcGraw@Blomand.net'
Subject: Omni Manual
Hi Bob,
Which series Omni is it (A, B, or C)? I probably have a
manual, depending on the series.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@speakeasy.net or W8EK@arrl.net
Voice Phone (352) 732-8400
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com] On Behalf Of Robert &
> Linda McGraw K4TAX
> Sent: Thursday, May 19, 2005 9:03 PM
> To: tentec@contesting.com
> Subject: [TenTec] Omni D Schematic/Manual
>
>
> Acquired a Omni D that has a low power output (35 - 45 watts)
> problem on all bands into 50 ohm load. I need a schematic or
> manual and suggestions. Power supply is running 13.5 V at
> the radio under load. Draws about 8 amps under tune (LOCK)
condition.
>
> Thanks in advance
>
> 73
> Bob, K4TAX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|