A high pass filter with a cut-off at 1.5 MHz should do equally well. A
constant K, T section, consisting of 2 series capacitors with an inductor to
ground designed for 50 ohms should work. Design it, build it, insert it in
line and forget it.
73
Bob, K4TAX
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, May 25, 2005 4:37 PM
Subject: Re: [TenTec] Eliminating BCI Overload
>A series tuned trap for each AM frequency can be placed antenna lead to
> ground.
>
> With a large paint can, you could install a Helical Coil Resonator notch
> filter to ground for each. The notch of the HCR can be 45 dB or more,
> depending on Q of the coil inside the shielding can.
>
> Stuart
> K5KVH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|