[Top] [All Lists]

[TenTec] CAT control of Argonaut II

To: tentec@contesting.com
Subject: [TenTec] CAT control of Argonaut II
From: kilcadzow <kilcadzow@i12.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 5 Jun 2005 21:28:09 +0100
List-post: <mailto:tentec@contesting.com>
I'm attempting to fix up CAT control on my Argonaut II. The codes go from the 
PC to the Argo, but only a bare acknowledgement is coming back.

I suspect I need to set the TX/RX identifier. The 305 serial interface points 
me to the 535/536 manual (on how to set it from the TX/RX keypad), but I 
can't find it.... The PC defaults to E0h.

Can anyone please help?

Many thanks,

Bob Towers
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>