Hello Dennis - I had the same issue. Check on a dummy load first as
suggested. My problem was the PIN diodes (D2 and D3) on the low pass
filter board and U-1 on the 9 Mhz board. Not too bad a job to
change...my first attempt at surface mount IC's and I did OK !!
Dennis Ashworth wrote:
>Well, maybe not a metering issue as the subject suggests, but the FWD power
>indication reads considerably low on transmit. All other meter functions
>appear normal. With the OMNI RF output set at 100W on a Bird watt
>meter the FWD meter on the OMNI jumps to 25W, then decays down to 10W over
>a couple seconds time.
>Any ideas? I haven't looked the schematic yet ... thought I'd collect ideas
>from the masses first.
>TenTec mailing list
B. Lee Cornwell
TenTec mailing list