But if the amp is QSK, why not just connect it for QSK with the enable in
and out connections...this way, not using the T/R relay?
----- Original Message -----
Sent: Wednesday, June 08, 2005 12:29 AM
Subject: [TenTec] RE : Keying Amp with my new Omni VI+
> Assuming the QRO amp is QSK capable will this permit the safe use of the
> RELAY OUT on the OMNI in "semi break-in" mode (i.e: slow QSK). Theres no
> way I'm going to want to mess with manual PTT in a cw exchange.
> Kirb, VE6IV
>>------- Original Message -------
>>From : Robert & Linda McGraw K4TAX[mailto:RMcGraw@Blomand.Net]
>>Sent : 6/6/2005 9:00:36 PM
>>To : email@example.com
>>Subject : RE : [TenTec] Keying Amp with my new Omni VI+
>>One point often missed or not understood is the QSK keying process when
>>using an amplifier. In the case of the Paragon series and the Omni series
>>the relay in the transceiver shouldn't be used to key the amp. Tentec uses
>>a "loop through" sequenced process for the QSK event timing.
>>I'll try to explain:
>>When the key is connected to the transceiver KEY jack on the rear and the
>>key is closed (line goes low) here's what happens. At this point the
>>transceiver RF section is not activated. The control signal goes to the TX
>>OUT jack (line goes low) which is connected to the KEY IN on the amp. This
>>line low keys the amp. The transceiver is still not activated. Once the
>>amp QSK circuit is activated the input and output relays have switched and
>>they have settled, then a signal is sent out of the KEY OUT jack (line
>>low) of the amp. This signal goes to the TX ENable jack on the
>>This is the point that the transceiver is activated and produces RF to
>>the amp. This sequence thus prevents hot switching within the amp.
>>If you elect to use the RELAY OUT on the transceiver to key the amp, you
>>have no way to prevent "hot switching" within the amp. The jumper is in
>>place between TX OUT and TX EN on the back of the transceiver. There is no
>>delay to allow the amp relay(s) to switch and settle. If your amp isn't a
>>QSK capable amp, then you're on your own. My suggestion is to use manual
>>PTT and not try to use QSK operation.
>>TenTec mailing list
> TenTec mailing list
TenTec mailing list