[Top] [All Lists]

Re: [TenTec] Orion NR problem

To: Ten Tec Mailing List <tentec@contesting.com>
Subject: Re: [TenTec] Orion NR problem
From: Gary Tuck <gtuck@mac.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 13 Jun 2005 14:43:09 -0700
List-post: <mailto:tentec@contesting.com>
Grant, I'm not sure.  I've been using either N4PY or HRD since last  
fall--and before 1.372 was released.  I didn't have the issue with NR  
under 1.371 using HRD but don't remember if I've experimented with NR  
and not had HRD running.  Will try it tonight.  Carl's program has  
many more features than I need and frankly, I prefer tweaking knobs  
than running the Orion from within the program.  I just use HRD to  
make a few quick changes to parameters which are easier in the  
Program than by knob turning--e.g., adjusting Threshold, making large  
frequency excursions etc.  My Orion just  made the trip and back from  
TT service for some hardware repairs--display screen and one VFO  
encoder--and was told that my issues with NR and Cut/PBT lag were  
firmware related.

Gary W7TEA
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>