TenTec
[Top] [All Lists]

Re: [TenTec] Orion and UPDATE mode.

To: Steve Baron - KB3MM <SteveBaron@StarLinX.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion and UPDATE mode.
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 03 Jul 2005 22:49:42 -0500
List-post: <mailto:tentec@contesting.com>
About 85% of them.

Bob, K4TAX


----- Original Message ----- 
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "TenTec List" <TenTec@contesting.com>
Sent: Sunday, July 03, 2005 3:42 PM
Subject: [TenTec] Orion and UPDATE mode.


>I posted the original this morning
> "Sun Jul 3 08:07:59 EDT 2005
>
>
> Turned on Orion this AM and screen says Flash Update Mode?
>
> After about 4 power on's over an hour, the system did load?"
>
> I got a few replies that the recall key may have been stuck.
>
> Don't think it was stuck, but I have a Bencher paddle with a Lucite cover.
> It was very close to the rig, close enough that  a small movement towaard
> the rig would put pressure on whatever button it contacted.
>
> SO, not an Orion problem at all.
>
> WOnder how many Orion problems are also initiated by operator actions
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>