TenTec
[Top] [All Lists]

Re: [TenTec] MUSHY KNOBS

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] MUSHY KNOBS
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 17 Aug 2005 21:57:35 -0500
List-post: <mailto:tentec@contesting.com>
Keep in mind that the primary business of Tentec is injection 
molding.........not ham radio.  So they make a few 100000 knobs or so. 
Also, they have a good tool and die shop too.  These 2 parts of the business 
pays for the ham radio hobby end of the business.

73
Bob, K4TAX


----- Original Message ----- 
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, August 17, 2005 7:12 PM
Subject: Re: [TenTec] MUSHY KNOBS


> Yes, Dave you could buy another knob from Ten Tec but it would break the
> same way the old one did.
> Some people don't even know it is split until they go to turn the 
> bandswitch
> and the knob just spins.
> So, if a better way is found to make a product better why no use it?
> Those non insert knobs have been a problem for Ten Tec too.
> It was just a poor design.
> Even Ten Tec would go with that feeling.
> 73,
> Dan/N4VET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>