TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ Filter configuration

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+ Filter configuration
From: "Michael, Dana A" <dana.michael@tycoelectronics.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 7 Nov 2005 10:29:14 -0500
List-post: <mailto:tentec@contesting.com>
Nar1 and Nar2 are the 9mhz positions.

1.8, 500 and 250 are 6mhz positions. 

Hope this helps.

73, Mike W3TS

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of NJ0IP
Sent: Monday, November 07, 2005 10:21 AM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] Omni VI+ Filter configuration

Pse help me out here.

It's been 2 years since I had an Omni VI+.

 

Please define for the VI+ (original - not the upgraded ones) what the
optional filter possibilities are.

 

As I recall, standard was 2.4 kHz in the 9MHz and 2.4 kHz in the 6.3 MHz
IFs.

Then there were 3 + 2 optional slots (5 total).

How many were in the 9MHz IF and how many in the 6.3 MHz?

 

One of the IF's had its filter slots labeled.  Which one was that?

The other IF just had two slots (Nar1 and Nar2).

 

Thanks for the help.

 

73

Rick

DJ0IP

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>