Re: [TenTec] Orion problem

["Carl Moreschi" <n4py@arrl.net>]

Don,

With the power off on the Orion, press and hold the user2 button.  While the
button is held, power on the Orion, continuing to hold the button for
several seconds.  If this doesn't work, you have a hardware problem.

Merry Christmas and 73,

Carl Moreschi N4PY
Franklinton, NC
----- Original Message ----- 
From: "Don and Diana Cunningham" <wb5hak@duracom.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, December 22, 2005 9:11 PM
Subject: Re: [TenTec] Orion problem


> Well, no go on the firmware update mode.  It doesn't seem to recognize any
> commands from the panel at all.  Darn!  Thanks for the try.
> 73,
> Don
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec