TenTec
[Top] [All Lists]

Re: [TenTec] 2.028 is out - error message

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 2.028 is out - error message
From: "Toby Pennington" <toby423@earthlink.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 9 Jan 2006 23:03:30 -0500
List-post: <mailto:tentec@contesting.com>
Ray, Before you click on "process", click on "settings" to be sure you have
the correct com port selected.  If you still have problems you can uncheck
"stop on errors" and then "OK".  I have done this on occasion and it seems
to work OK. Be sure your rig is in the flash mode of course.

Toby  W4CAK


----- Original Message ----- 
From: <RaySoifer@cs.com>
To: <tentec@contesting.com>
Sent: Monday, January 09, 2006 10:42 PM
Subject: Re: [TenTec] 2.028 is out - error message


> Please forgive this dumb question, but now that I've downloaded the new
> firmware, what do I do now?
>
> I plugged the serial port into both computer and O2, installed the
software
> into the computer, hit "process" and selected "install 2.028."  It begins
the
> process only to give me an error message "Communication with the radio has
> failed."
>
> I have a feeling that I was supposed to do something to configure the
serial
> port(s), but I cannot find anything that tells me what to do.
>
> Can one of you experts shed some light?
>
> Tnx,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>