[Top] [All Lists]

Re: [TenTec] Now UPS Strikes Again

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Now UPS Strikes Again
From: "Lew" <ljl160@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 11 Feb 2006 01:09:21 -0500 (Eastern Standard Time)
List-post: <mailto:tentec@contesting.com>
I learned that packing for UPS must withstand a good 6 foot  drop at minimum
 I live near a main UPS drop off and I've seen just from the counter to the
back room what happens. DHL is my new mode of shipping- its been very good
so far. K1NDV 
-------Original Message-------
From: Robert & Linda McGraw K4TAX
Date: 02/10/06 23:11:52
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Now UPS Strikes Again
UPS is an absolute pain in the behind company to do business with.  I too
received a package via UPS in October.  It was a "drop and run" job thus no
signature.  Damaged to such extent the outside of the box was torn, the
inside packing was damaged, the inside box was torn and the inside packing
damaged as well as the radio equipment.  Filed a claim with UPS, then they
said it had to go back through the shipping agent and they'd have to make a
claim.  Then they said the damage was due to inadequate packing.  Come on
folks, it doesn't take a high school drop-out to figure that one out.  Well
what would one expect?  I guess if it were in a iron box it might have made
it.  Oh well the story continues.
Well all was done as they requested.  Pictures made and sent as requested.
Package delivered to the local UPS office as requested.  On and On and On
and On.  Finally, I figured that their tactic was to stall and stall and
stall and perhaps I'd just go away.  Well I didn't.  I persisted in being a
thorn in their behind day after day after day.  Finally, after 4 months I
got a check but only after they got a letter from my attorney and then a
summons to appear in local court.
Bob, K4TAX
TenTec mailing list
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>