I've the Orion 1 (AT) with the original software.
I note that when I've got the PWR set above 70, the meter needle
slams into the stop (this on CW.)
Is there a way to reduce the meter's sensitivity such that I can run
full power and not peg the meter on each dit and dah?
Also, I like to run QRP and find that even with the PWR all the
way down, I can't go below @7 watts on 30, 40, 80 or 160.
I'd like to be able to have "1" on the PWR indicator be between 4 and
4.8 watts out.
Lastly, is there some manner of software that would cause the Orion
to "band scan" wherein I would set an upper and lower frequency limit
and a rate and the unit would tune between these frequencies?
Tim Colbert K3HX
Try Juno Platinum for Free! Then, only $9.95/month!
Unlimited Internet Access with 1GB of Email Storage.
Visit http://www.juno.com/value to sign up today!
TenTec mailing list