[Top] [All Lists]

Re: [TenTec] TenTec Digest, Vol 38, Issue 62

To: <tentec@contesting.com>
Subject: Re: [TenTec] TenTec Digest, Vol 38, Issue 62
From: "Lou Laderman" <lladerman@earthlink.net>
Reply-to: lladerman@earthlink.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 14 Feb 2006 19:27:43 -0600
List-post: <mailto:tentec@contesting.com>
My SP is working, I can definitely hear added compression when it is
turned on. However, as reported by W4CAK, there is little if any
difference between setting 1 or 9. 

I also noticed a loss of audio from 100-200Hz, but it's not

I did not notice any increase of noise with the hardware NB turned on.


Message: 8
Date: Tue, 14 Feb 2006 17:48:49 -0500
From: "Toby Pennington" <toby423@earthlink.net>
Subject: Re: [TenTec] Orion I V2 beta
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Message-ID: <005101c631b8$d2b04a30$6401a8c0@TOBYROOM>
Content-Type: text/plain;       charset="iso-8859-1"

Mark,  The audio indeed is rougher on the edges and not as robust as in
1.xxx versions.  Here are a few other issues for someone to confirm and
then report...........

1. SP is not working,  very little change between settings of 1 to 9 2.
The rolloff is acting like a VFO,  the higher you roll it up the lower
the transmit frequency
    is,  and the lower you roll it off the higher the transmit frequency
goes.  In other words,
    instead of the rolloff changing the audio it is changing the
transmit frequency of the rig.
    This is according to on the air tests made this afternoon. 3.
Hardware noise blanker actually increases noise instead of reducing
noise.  This was
    checked out on a quiet band.  Some disagreement on this issue. 4.
The loss of audio when going from 200hz down to 100hz  cw mode seems to
be in the
     order of 4 to 5 db loss.  Too much loss of audio.

All this needs to be confirmed by others.     Toby  W4CAK

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TenTec] TenTec Digest, Vol 38, Issue 62, Lou Laderman <=