Do you know about the requirement to use a high pass filter between the
Orion and Acom 2000A?
http://www.rfsquared.com/cms-files/Acom-Orion%20Note.html
73,
Barry N1EU
On 2/14/06, Kamal Sirageldin <ksira@corpten.com> wrote:
>
>
> I decided to try the V2.054 Beta upgrade. Did the hardware mod for the
> Sweep (works great).
>
> I did seem to find one problem, although I wish I could provide more
> detailed information to help determine the cause.
>
> Since last spring, I have used an Acom 2000A amp with the Orion - no
> problems. I use V1.372 firmware.
>
> After installing V2.054, I cannot key the amp without it throwing the amp
> into protection. Can't tell if it is because the initial RF waveform
> output
> of the Orion is too high, or if RF is present before the AMP Key line keys
> the amp. I use a simple keying cable from the Orion AMP KEY jack to the
> Acom
> key line input.
>
> The strange thing is that the rig keying throws the amp into protection
> even
> when I have the Orion RF output power set to one (1) watt (normally I
> drive
> the amp with 42 watts).
>
> CW QSK is set for 21%.
> EXT T/R Delay 1 is set for 23%
>
> Something strange is going on - and it's definitely a V2.054 issue, I
> re-installed 1.372 and things work fine with the amplifier. The 2.054
> problem with throwing the amplifier into protection is both in CW and SSB,
> and on multiple bands.
>
> I also noticed that the "MON" seemed to have feedback or was extremely
> sensitive to level - even when cranked down to a "2". This did not happen
> with V1.372 - I probably need to change the mic gain and SP settings to
> different values for 1.372 vs 2.054. I use a Heil Quietphone Headset with
> HC-4 element.
>
> I noticed that the Sweep function works great in V2.054.
> Appreciate how compressed some of the setup knob turning is with 2.054.
> Setting AGC Threshold is no longer an endless knob turning affair.
> The audio fidelity in 2.054 does not distort with very strong signals like
> it sometimes did in 1.372. Good job.
> I'm not sure, but the receive audio sounds smoother in 2.054.
> Screen display seems crisper too.
> S-Meter is definitely more generous with strong signals. Never seen so
> many
> needle pinning signals.
>
> Re-installed 1.372 so I could use the amp, but looks like lots of nice
> touches in V2.054.
>
> 73 Kam N3KS
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|