Same results on my rig.
Alan N5NA
John Buck wrote:
With my Orion 2.054 upgrade, the headphone audio can be reliably killed
by the following procedure.
Place the sub receiver in AM mode.
Make sure T and R are on the main vfo, any frequency, any mode.
Touch the TX Key or PTT.
The headphone audio does not come back until you either cycle power or
else reset the sub receiver to some mode other than AM and touch TX
again. The speaker is unaffected.
This is not an RF problem. Low power, Dummy Load, TX on SSB without
speaking, all the same.
I believe the problem never shows up if you do not put the Sub receiver
into AM mode.
The problem also does not show up if you reverse the process, that is
main receiver AM and sub not AM.
I have reported to Ditsnbits.
|