Same results on my rig.
John Buck wrote:
> With my Orion 2.054 upgrade, the headphone audio can be reliably killed
> by the following procedure.
> Place the sub receiver in AM mode.
> Make sure T and R are on the main vfo, any frequency, any mode.
> Touch the TX Key or PTT.
> The headphone audio does not come back until you either cycle power or
> else reset the sub receiver to some mode other than AM and touch TX
> again. The speaker is unaffected.
> This is not an RF problem. Low power, Dummy Load, TX on SSB without
> speaking, all the same.
> I believe the problem never shows up if you do not put the Sub receiver
> into AM mode.
> The problem also does not show up if you reverse the process, that is
> main receiver AM and sub not AM.
> I have reported to Ditsnbits.
TenTec mailing list