[Top] [All Lists]

Re: [TenTec] [Orion] Orion II ad in QST

To: tentec@contesting.com
Subject: Re: [TenTec] [Orion] Orion II ad in QST
From: Don Rasmussen <wb8yqj@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 21 Feb 2006 15:06:01 -0800 (PST)
List-post: <mailto:tentec@contesting.com>
The solution is simple - remove the digital design
component from the radio. Tell the chaps on the line
to always make sure the tip of the soldering iron is
hot and clean when making connections and to inspect
their work. 

What, it's too late for that? ;-)

Re: [TenTec] [Orion] Orion II ad in QST
from [Chortek, Robert L] [Permanent Link][Original] 
Subject: Re: [TenTec] [Orion] Orion II ad in QST   

Fellow Reflectees,

After considerable research, it became clear that
there were many problems with the 9000 and that the
factory service was not commensurate with the
expenditure ($11,500.00 for the "D") - all well
documented on that reflector.   

I came to the conclusion that the purchase would be a
"gamble."  Pay $11,500 and keep my fingers crossed
that the rig would perform as advertised 

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>