You don't need an ALC line from any linear when using a
ten-tec transceiver. Since the ALC adjustment on the TT sets the
maximum power that the transceiver will transmitt. Just tune up
the linear as normal with maybe 50-75 watts and then adjust the
ALC adjustment until the power output goes to maximum and leave
it there. At that point the linear has all the drive it needs and
the transceiver won't transmitt at a higher level.
73 Jim K4CGY
--- John Nason / NA9U <firstname.lastname@example.org> wrote:
> Speaking of amps, I never found a way to feed the ALC
> line back from the amp to the O2. Is this unecessary
> on the O2? Do I keep missing it in the manual?
> John NA9U
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
TenTec mailing list