Evercool 50mm Type I Frame
VGA Cooler Replacement FanLow noise, long life time, heat dissipation
Evercool EC5010M12S-I 50mm fan, 2 Pin. Good for VGA card cooler replacement fan.
Voltage VDC: 12;
Current AMP: 0.13,
Input Watts: 1.56,
Fan Speed: 4500,
Air Flow: 10.25 CFM.
Noise dBA: <23.
Power Connection: 2-Pin Female.
Dimensions: 50 x 10mm
The factory supplied fan on this rig really whines, to the point it
drove me to try some other alternatives. Found this inexpensive
50mm fan on the Internet and was pleased with Directron's
The fan mounts on the heat sink using two of the original mounting
screws with the label and frame against the heat sink. The two pin
plug goes into the three pin connector on the board, red wire to Vcc
and black wire to ground. Don't over tighten the screws or it will flex
the fan's thin back support.
It blows down into the heat sink like the factory fan and
without the side shroud I think it even cools to the sides better. I
run CW only and it cools just fine in this mode. Observe all static
precautions when inside the radio.
Now when I turn the volume all the way down I hear only silence.
John - w7ccw
Brings words and photos together (easily) with
PhotoMail - it's free and works with Yahoo! Mail.
TenTec mailing list