TenTec
[Top] [All Lists]

Re: [TenTec] Orion II and Centurion

To: "Ron Castro" <ronc@sonic.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II and Centurion
From: "Chortek, Robert L" <robert.chortek@berliner.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 25 Feb 2006 12:28:26 -0800
List-post: <mailto:tentec@contesting.com>
Hi Ron,

I have a peak reading watt meter, and I just compared the two peaks (one
from Amp driven by the Orion and the other from the Amp driven by the
FT1000D.

By the way, I very much enjoyed your write up and found it helpful.

Bob/AA6VB

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Ron Castro
Sent: Saturday, February 25, 2006 11:16 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion II and Centurion

Bob:  How are you determining the output of the Centurion on SSB?  I
believe that if you looked at the output on a spectrum analyzer, you
would find that the Orion II is driving it to a true PEP value that is
equal to the CW 'key down' power, and maybe even slightly more due to
power supply sag in the linear.  The FT1000 may have a higher
average-to-peak ratio than the O2, showing more input and output power
from the linear on any kind of meter that does not measure absolute
instantaneous PEP.

There should be more average power in and out with SP on, but I have not
seen this, and believe that this is an area that the TT engineers should
look at.  To be sure, the SP does tend to give a little more aggressive
sound, so it does help when you need the extra punch, it's not yet the
equal the typical built-in or external SP's.  That is on my Fix List I
sent to TT and available at www.ronc.users.sonic.net .


Ron
N6AHA

----- Original Message -----
From: "Chortek, Robert L" <robert.chortek@berliner.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 25, 2006 10:42 AM
Subject: [TenTec] Orion II and Centurion


> Hello Fellow Reflectees.
>
> I have an Orion II and a Centurion Amp. I can only get about 600 watts
> out of my Centurion on SSB when driven by the Orion, but about 1KW
when
> driven by the FT1000D. I get the full KW+ on CW from the amp when
driven
> by either rig.  Does anyone have the same combination and if so, do
you
> get full output from the Centurion on SSB when driven by your O II?
If
> so, what are your power, mic and speech processor settings (and any
> other relevant settings)?
>
> Thanks for your help.
>
> 73,
>
> Bob/AA6VB
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>