Have you learned your lesson? Don't complain about noise. Just live
with it, or you may end up in jail, hi.
Yesterday I cured a terrible noise problem. I tracked it down to a
small neon sign above Laundromat in a strip-mall 1.5 miles from my
house. I called the manager and told him about the interference. Two
nights ago, I was walking around with my 12-year-old son inside the
Laundromat with a field strength meter tracking the noise, and when I
walked out the door, I saw six cops walking briskly toward me, while
more cop cars were screeching up in front of the building. Even the K-9
unit was there!
----- Original Message -----
From: "Grant Youngman" <email@example.com>
To: "'Discussion of Ten-Tec Equipment'" <firstname.lastname@example.org>
Sent: Saturday, February 25, 2006 1:22 PM
Subject: Re: [TenTec] [Orion] Orion II Noise Blankers
>> 2. For me, the hardware NB works somewhat but the s/w NB does
> I suppose it depends on the characteristics of the noise. I have a
> strong pulse noise in my neighborhood (don't know from what, it's a
> "pop" about once per second) and both the HW and SW NB's take it out
> perfectly. But my noise isn't your noise, and luckily the power
> fixed the arcing insulator on the pole pig behind my house a couple of
> ago. THAT was NOISE :-)
>> The DR is what does nothing for me. It operates, but it makes
>> the signals much less intelligable on SSB for a neg negative,
>> and is simply makes copying cw signals impossible in some
>> cases. I can't even use it.
> Did you mean NR? I hear a little distortion on SSB. I can't say I've
> it makes signals "much less intelligible". For SSB I run it at "1" or
> almost all the time, and it cleans things up very nicely. There is
> distortion. I'd rather listen to a little of that than the watery
> the typical external LMS noise reducer, although I hope it gets
> in a future release.
> I spent some time rereading the manual again, and it reconfirmed some
> comments I made earlier. Which is that on CW, if you're already using
> narrow filter, the NR may not add anything, and may in fact make
> worse. That's partly because the NR is effectively nothing more than
> another very narrow filter around the CW signal. And partly because
> effectiveness can be diluted if threshold is set to a high value,
> explicity in the menu or if RF gain is reduced. The manual is pretty
> on this, and has a reasonable discussion about when it will and may
> plus to use NR, how to set threshold and NR levels for best
> etc. It's function is to improve S/N ratio, not get rid of the noise.
> Interestingly, the II manual indicates that Threshold is automatically
> reduced when NR is turned on, and although that did happen in the
> 1.xxx and was very obvious, it isn't obviously occurring in the II.
> radio behaves like that isn't happening at all.
> TenTec mailing list
TenTec mailing list
TenTec mailing list