You should not turn the ALC on the Triton IV "all the way up". The amount
of ALC should be set so that the ALC light just winks on your voice peaks
for whatever band you are transmitting on.
73, Larry WB4WSA
----- Original Message -----
From: "Danny Shaver" <n5nbk@nortexinfo.net>
To: <tentec@contesting.com>
Sent: Saturday, February 25, 2006 6:14 PM
Subject: [TenTec] Voltages on 262G power supply
Hello Ten-tec techies, I need some help!!
I have a 262G power supply that I just got with a Triton IV.
I am getting distorted SSB transmit reports when I turn the ALC up all the
way on all bands. It is fine when I put the ALC at about 50%.
The voltage out of the supply is 12.95 volts on receive. In transmit with
50% ALC it drops to 12.5 to 12.67 volts, and at 100% ALC it goes to 12.24
to 12.35, depending on band. I am testing into a 50 ohm dummy load. What
do you think?? Thank you for your help in advance.
Dan N5NBK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|