[Top] [All Lists]

Re: [TenTec] Voltages on 262G power supply

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Voltages on 262G power supply
From: w8au@sssnet.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 27 Feb 2006 15:40:53 -0500
List-post: <mailto:tentec@contesting.com>
At 03:03 PM 2/27/06, James C. Owen, III wrote:
>    I think you should crank the voltage up to the rated 13.9V.
>I'm not familar with the 262G supply but I assume it's like most
>others in that is has a voltage adjustment pot inside.

There is no voltage adjust inside.  Only a crowbar adjustment for

However, you can jack up the voltage to 13.8 or so by adding a
series diode or two to the reference diode already there.
(.6V for each added silicon diode)

Works fine.

Perry w8au

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>