TenTec
[Top] [All Lists]

Re: [TenTec] Problem: Please confirm Orion II Radios

To: "Carl Moreschi" <n4py@arrl.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios
From: <n4zz@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 3 Apr 2006 06:38:40 -0500
List-post: <mailto:tentec@contesting.com>
My Orion with version 2.056 fails in this scenario.

following steps:

1) Set NB to 2
2) Set NR to 2
3) Turn on manual notch and it fails

I tried some different nrs and it did not fail.

Don n4zz
----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 02, 2006 10:57 PM
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios


> My OII does fail in this scenario.  I just did a battery reset followed by 
> a
> master reset and it still fails.
>
> My fails with just 3 steps:
>
> 1) Set NB to 2
> 2) Set NR to 2
> 3) Turn on manual notch and it fails.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message ----- 
> From: "Douglas Shock" <douglas.shock@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, April 02, 2006 11:27 PM
> Subject: Re: [TenTec] Problem: Please confirm Orion II Radios
>
>
>> Phil,
>> Mine did the same. Do a abttery reset, then a master reset...the problem
>> never occured again
>>
>> On 4/2/06, AI4DQ@aol.com <AI4DQ@aol.com> wrote:
>> >
>> > Version 2.032 software
>> > When operating my new Orion II this am Had terrible Noise with NB set 
>> > to
>> > 2  ,
>> > NR 3, Notch on and the SP set 3 and sweep on  I then went notch
>> > C  position
>> > rotating the Down from 1000HZ  when I get past 900HZ  I lose  audio and
> is
>> > replaced with crackling sound The only way to restore the audio is  by
>> > turning the
>> > radio off and on a reset is not required. I would like others to
> confirm,
>> > And I have one other owner confirm(WB4QDA) this Bug. and would
>> > like  everyone to
>> > confirm this. I tried others setting but the NB has to be on and the 
>> > NR
>> > has
>> > to be on as well as Notch.
>> >
>> > Phil AI4DQ
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>> >
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>