TenTec
[Top] [All Lists]

Re: [TenTec] Orion - K3NA transmit audio chain article nowonTen-Tecwebsi

To: tentec@contesting.com
Subject: Re: [TenTec] Orion - K3NA transmit audio chain article nowonTen-Tecwebsite
From: Duane A Calvin <ac5aa@juno.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 3 May 2006 13:29:04 -0500
List-post: <mailto:tentec@contesting.com>
Sinisa,
        What do you recommend then as a method for picking off a sample
for the 'scope?  Is there a relatively inexpensive method that gives
reliable results?

        73,  Duane


On Wed, 03 May 2006 13:38:46 -0400 Sinisa Hristov <shristov@ptt.yu>
writes:
> Quoting from page 7:
> 
>    Amplifier linearity check
> 
>    Since you have made the transmitter adjustments at the full
>    power level appropriate for your class of entry, the monitor 
> receiver?s
>    audio has included any impairment introduced by the
>    power amplifier (if used).
> 
>    An oscilloscope can provide a quick check for linear operation
>    of an amplifier. Wind a length of hook-up wire around the coax
>    line connected to the amplifier input and another length around
>    the output coax. Increasing the number of turns will increase 
> the
>    signal picked off the coax; I find this simple approach picks up
>    enough signal to deflect the scope beam. Connect one wire to the
>    scope?s X input via a probe, and the other wire similarly to the 
> Y
>    input. Adjust the X and Y gain controls so that, while 
> transmitting
>    the recorded message, a diagonal line of around 45° appears on
>    the scope.
> 
>    Examine this line, focusing particularly on modulation peaks. If
>    the diagonal line remains straight and the audio quality is good 
> in
>    the monitor receiver, the amplifier is operating linearly 
> (good!). If
>    the tip of the diagonal line starts to deviate away from 
> straight,
>    even just a little amount, then the amplifier has moved into 
> nonlinear
>    operation. You?re definitely transmitting some garbage on
>    the bands then!
> 
> 
> It's difficult to imagine a more unreliable way of sampling
> amplifier's input and output signals.
> 
> A wire wound around coax is a capacitive probe picking an
> undeterminate mixture of coax leakage and common mode voltage.
> 
> The later is likely to dominate, even on the "input" probe,
> invalidating the test because it originates mostly from the
> amplifier output (i.e. coax - antenna junction).
> 
> 
> 73,
> 
> Sinisa  YT1NT, VE3EA
> ____________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 


Duane Calvin, AC5AA
Austin, Texas
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>