|Subject:||[TenTec] OMNI6+ SSB transmit quality - HELP!|
|From:||"Fraser Robertson" <firstname.lastname@example.org>|
|Reply-to:||Discussion of Ten-Tec Equipment <email@example.com>|
|Date:||Tue, 04 Jul 2006 20:56:53 +0000|
Hi all, is possible to transmit good quality SSB from this rig? I get
reports of muffled audio. Listening on another RX I know what they mean.|
I've re-aligned the driver & pa bias, carrier oscillators etc. I've isolated the mic ground as by design it shares the PTT ground and digital noise was getting into the mic amp.
With a two tone test the signal looks ok on a scope and spectrum analyser (products 26dB and 38dB down).
I've tried different power supplies, different mics and audio sources.
It sounds reasonable on receive, to me anyway, and works well on CW.
The rig has the stock filters fitted. A friend has the Inrad SSB filter and says he gets muffled audio reports too.
I've ruled out RF feedback and am running out of ideas. Any advice would be appreciated. The audio is readable but not crisp clear quality. (The rig is an upgraded Omni6).
Thanks / 73 Fraser G4BJM
Windows Live? Messenger has arrived. Click here to download it for free! http://imagine-msn.com/messenger/launch80/?locale=en-gb
_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
|<Prev in Thread]||Current Thread||[Next in Thread>|
|Previous by Date:||Re: [TenTec] 238 elastic cord replacement?, Ed|
|Next by Date:||Re: [TenTec] Lousy eHam review, steve moore|
|Previous by Thread:||Re: [TenTec] Sweep on Orion II, Reg Unsworth|
|Next by Thread:||Re: [TenTec] OMNI6+ SSB transmit quality - HELP!, Dr. Gerald N. Johnson|
|Indexes:||[Date] [Thread] [Top] [All Lists]|