I may be placing an order soon! The software works with AC Log running at
the same time?
----- Original Message -----
From: "Carl Moreschi" <email@example.com>
To: "Discussion of Ten-Tec Equipment" <firstname.lastname@example.org>
Sent: Thursday, July 06, 2006 1:42 PM
Subject: Re: [TenTec] Ham Radio
> My software also now offers a main/sub calibration. I am finding my Orion
> II shows a consistent 6 hertz difference between the 2 receivers. My
> software now perfectly corrects this when in diversity mode.
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "Grant Youngman" <email@example.com>
> To: "'Discussion of Ten-Tec Equipment'" <firstname.lastname@example.org>
> Sent: Thursday, July 06, 2006 4:28 PM
> Subject: Re: [TenTec] Ham Radio
>> > >this morning. The only specific comment I'd make now on the 4 items
>> > >below is that #4 is the design of the Orion and Orion II - the
>> > >receivers are not phase-locked together. There is no
>> > firmware change
>> > >available to alter this.
>> Well, maybe it's necessary to think outside the box a bit.
>> While it may not be possible to phase lock the receivers, perhaps it's
>> possible to get a bit closer through a fixed (or variable) calibration
>> adjustment. N4PY offers a "calibration" feature in his remote control
>> software that permits setting the display to the correct frequency when
>> master reference oscillator (and thus display calibration) is off a tad.
>> I've always thought this concept could be applied in T-T firmware to
>> the need to tweak the master reference when the radio is off a few Hz,
>> perhaps it could be applied to the Main/Sub difference as well -- not a
>> phase lock soltuion, but not off 6 Hz, either.
>> Seems straightforward, but I could just be slow -- and I'm sure many
>> agree the latter is the case :-)
>> TenTec mailing list
> TenTec mailing list
TenTec mailing list