I found the same thing ( v. 2.034), but you can get out of the transmit
lock-up by hitting the keypad again.
----- Original Message -----
From: "Joerg Vollbrecht" <firstname.lastname@example.org>
To: "Discussion of Ten-Tec Equipment" <email@example.com>
Sent: Monday, July 10, 2006 3:32 AM
Subject: Re: [TenTec] VOX and CW
> Just the same over here!
> 73, Joe Vollbrecht (DL4CF)
>>Klaus Heintzenberg wrote:
>>>Menu-CW-PTT in CW as: MOX
>>>Internal Keyer ON
>>>Choose some band with band-change keypad.
>>>Set up SSB mode with VOX=ON on one of the bandstacking registers.
>>>On the next bandstacking register set up the radio in CW mode.
>>>Now go to SSB by band change keypad and make sure VOX is ON
>>>Then press pad to change to the CW band segment. Then the VOX sign
>>>on the display changes.
>>>Now tap on the microphone or whistle into the mic while in CW mode.
>>>My radio then goes into transmit and puts out a constant carrier at the
>>>output power level!
>>>The only way to shut of the carrier is to hit the main power switch.
>>>Should'nt the VOX be disabled while on CW?
>>>Imagine you changed from SSB to CW. Then, while leaving the room for the
>>>bathroom, you slam the door shut. That may take the Orion into transmit.
>>>When you return your amplifier may have gone up in smoke...
>>>Can anybody else reproduce this?
>>>73, Klaus (DJ6RX)
> TenTec mailing list
TenTec mailing list