[Top] [All Lists]

[TenTec] ORION2_SteppIR_Interface

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] ORION2_SteppIR_Interface
From: "G" <goofyham@highstream.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 12 Jul 2006 15:26:27 -0400
List-post: <mailto:tentec@contesting.com>
I was hit with lightening the other day and my O2 to SteppIR control box are no 
longer on the same page. Normally, when I change the O2's frequency the SteppIR 
box changes the beam to the same frequency.
After the jolt by Mother Nature they aren't talking.
The SteppIR box works fine in the manual mode.
My question is. Is there a free down load O2 program I can run and control the 
O2? I can take the DB9 off the SteppIR box and connect it to the computer to 
see if the computer talks to the O2 to prove the O2 or the SteppIR box.
Or is there an easier way to prove the O2's interface isn't the cause.
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>