Bravo to Bill, W4ZV, for providing some insight into the ongoing technology
migration. You are exactly right about the technology ramp up at Warp speed,
and this is very exciting.
Unfortunately, many of the old die hard amateurs do not like to see such a
rapidly evolving technology environment. It scares them.
So, my philosophy, is to not get hung up on the TenTec versus Flex Radio
versus ICOM and now versus the new Yaesu FT-2000 which is also going to be a
Just enjoy the ride, and use the rig of your choice, as there are going to
be many choices......
FYI, The new 1500 Watt Solid State Amplifier that has been announced by
Elecraft at Dayton, is probably going to be the first amplifier in the
amateur radio industry that is solid state and runs 1500 watts out. How
revolutionary is the fact to not have to ever buy an expensive pair of
replacement Ceramic Tube finals in the future.
So, between the evolution of the Stepp-IR antennas, the upcoming solid state
autotune amplifiers, and these new family of rigs, is amazing to see.
And finally, for the die hard aluminum antenna guys, the new OptiBeam family
of antennas are amazing. They are built like the old Telrex as far as
structural, however, remind me of Force 12 antennas on Steroids. They have
just announced a 40 meter MOXON antenna that has the same performance as a 2
element 40 meter beam, however, this MOXON antenna can be closed spaced 5 to
8 feet above a multi-band yagi without any interaction.
Lots of great choices.
Should be fun.
From: email@example.com [mailto:firstname.lastname@example.org]On
Behalf Of Bill Tippett
Sent: Saturday, July 15, 2006 9:02 AM
Subject: [TenTec] SDR-1000 vs Orion vs SDR-X
>It seems time to reaffirm that the SDR 1000 is a direct conversion radio
can never, no matter how much software it has, equal the performance of a
Ten Tec receiver in the Orion. You can't put selectivity after the front
end and fix problems inherent to the front end. That is what the close by
signal sensitivity to overload is about with DC radios.
Stuart this is contrary to my understanding
and ARRL's Product Review as reported in October QST.
Could you be more specific about your comment and
compare appropriate ARRL measurements (IMD, BDR, etc)
from their Product Tests?
For my own curiosity I checked the two QST reviews
of the SDR-1000 (1st = 16 bit soundcard in April 2005 QST,
2nd = 24 bit Delta 44 soundcard in October 2005 QST) with
the January 2004 review of Orion. Generally the data
below is Preamp Off, 500 Hz, 14 MHz and 5 kHz spacing.
In the case of the second SDR-1000 review, I did use
a preamp setting to get MDS within the same ballpark,
and the review also notes that the measurements on
that unit are identical at 2 kHz spacing versus the
5 kHz results compared below:
Radio MDS BDR IMD 2nd order intercept
Orion 128 130 92 63
SDR(1st) 127 93 86 69
SDR(2nd) 130 111 98 74
An ad hoc group of Flexers is working on an even better
soundcard (named the Janus project) than the Delta 44
used in SDR(2nd) above. Initial results indicate MDS
of -160 dBm and dynamic range of 120 dB for Janus but
these may not translate directly to the measurements
above. Typically direct conversion SDRs are most
dependent on soundcard (i.e. ADC and DAC) performance
(as can be seen in SDR(1st) vs SDR(2nd) above. More
info on the Janus project:
Update 26 May 2006
The results of the ADC bake-off are in and the AK5394A is the clear
winner for our particular application due to its flat noise floor at 192kps.
The measured figures of the prototype Janus using the AK5394A are:
Noise Floor = -160dBm (in an 11Hz FFT bandwidth) Dynamic Range =
120dB ENOB = 20 bits
We are now at the final review stages of the Janus circuit and expect
to be moving to prototype PCB manufacture very shortly.
Bottom line is I question Stuart's comment above
based on ARRL's actual measurements. I feel the direct
conversion DSP approach Flex is using is already delivering
*better* RX performance than Orion and it is likely to
get even better when the Janus project is completed.
SDR-X may be a very significant product because of:
1. Excellent RX performance already demonstrated in SDR-1000.
2. Modular configuration allowing multiple RX and TX
modules in the same mainframe (i.e true SO2R in one box).
3. True phase-locked diversity with as many receivers
as you can afford (up to 64 modules total).
4. New capabilities never seen before such as rejection
of inband interference correlated with a signal from a
second RX module (this is the most exciting to me).
I agree with N9DG's comments that we may be on the
threshold of some very significant changes in the landscape
of our rigs and manufacturers. Ten-Tec has done well by
being very responsive to performance oriented customers
and I have no doubt they will continue to do so, but the
competitive landscape may be changing at warp speed.
73, Bill W4ZV
P.S. For those who think Flex is a garage shop, keep in
mind that Gerald Youngblood K5SDR has started a number of
high-tech companies and is presently a hedge fund manager
(with easy access to venture capital markets). I believe
Flex's real goal is commercial/government/military and
the SDR-1000 is just a warm up for the SDR-X.
TenTec mailing list
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.10.1/389 - Release Date: 7/14/2006
TenTec mailing list