I just hooked up the 302r to my Orion 2. I not sure if I'm doing
something incorrectly or if they 302r is not operating correctly. I
cannot get the 302r to change bands as discribed on pg 34 of the Mar.
2006 manual. I have Rem Pod Enter in the menu set to VFO A, yet when
push any of the buttons on the remote pad other than 5, 6 and 1
nothing happens. When I push 5,6,1 only the freq in the band stack for
20 meters change. I'm sure I am doing something wrong but I can't
fiqure out what. Also when I push F1 F2 or F3 the Frequency goes blank
on VFO A and I can't input a frequency with the pad.....Vin
There appears to be some sort of bug
that switches between VFO A and VFO B. Sometimes
it works correctly and sometimes it changes VFO B.
This is using Orion/V1.373b5 firmware.
It "should" work as follows:
1. Menu-Other Remote Pod F1 VFO A Ent (then exit Menu)
2. On Pod, press F1 and A display should show __.___.___
3. On Pod, press 14025E, and display should be 14.025
But in my unit, #3 above often results in VFO B = 14.025.
Send a note to firstname.lastname@example.org to report bugs.
73, Bill W4ZV
TenTec mailing list