TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II and SWR meter reading

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II and SWR meter reading
From: "Denton" <denton@oregontrail.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 9 Aug 2006 07:54:56 -0700
List-post: <mailto:tentec@contesting.com>
A subnote...if I connect my Mirage MP-1 line sensor directly in back of my 
Paragon II, then the swr readings on the MP-2 and rig will jive...even on 10 
meters.
----- Original Message ----- 
From: "Denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, August 09, 2006 7:51 AM
Subject: Re: [TenTec] Paragon II and SWR meter reading


>I notice the same on this end....Paragon II, 238B atu and MFJ-259B 
>analyzer.
> Also, my Mirage MP-2 wattmeters indicate a different power output reading
> from the rig and atu if other than full power output from the Paragon II.
>
> ----- Original Message ----- 
> From: <ARDUJENSKI@aol.com>
> To: <tentec@contesting.com>
> Sent: Wednesday, August 09, 2006 7:45 AM
> Subject: [TenTec] Paragon II and SWR meter reading
>
>
>>I noticed that not in all cases will the meter (set to SWR) in the Paragon
>> II read exactly the same as that is the 238 ATU. By the way the 238 and
>> the
>> Paragon are connected by an 18 inch quality jumper (Belden 8214).
>>
>> I found a discussion on the topic in the ARCHIVES at
>> _http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html_
>> (http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html)
>>
>> Basically this section in short says to believe the meter in the rig.
>>
>> SITUATION: I did notice that if I turn the  AGC button to OFF the  meter
>> will
>> match the ATU meter. (By the way I use a MFJ 249 Analyzer to find the
>> settings for the ATU but find in some cases it still needs to be tweeked
>> when I
>> push TUNE.)  Is this normal? I could not find anything in the manual that
>> even
>> mentions the AGC in conjunction with operation of the SWR/TUNE set  up.
>>
>> Is this normal or do I have a problem I need to look into?
>>
>> Thank you
>>
>> Alan  KB7MBI
>> Woodinville, WA
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>