Don't know if you are aware of them but Almost All Digital Electronics
(AADE) sells some frequency counter/display units.
You can check them out here: http://aade.com
Specific information for use on different types of rigs:
Digital Frequency Display Applications Notes
http://aade.com/Applic~1.htm
73, Mike N4NT
----- Original Message -----
From: "Shawn Upton" <kb1ckt@yahoo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, September 05, 2006 10:11 PM
Subject: Re: [TenTec] Century 22 Question
| What's wrong with tapping off the PTO? The TenTec
| PTO's I've seen seem to have a decent amount of drive,
| and the freq displays have a decent input
| impedance--meaning low loading. I suppose you could
| tap after the amp that drives the mixer on the mixer
| board, though.
|
| Shawn KB1CKT
|
| --- Don Rasmussen <wb8yqj@yahoo.com> wrote:
|
| > Hi Guys,
| >
| > I am considering changing the tuning indicator on my
| > Century 22 from the dial string to a small frequency
| > counter display. Can anyone suggest a method of
| > getting a signal sample, other than sampling the PTO
| > itself? I am not a EE but I can solder and follow
| > instructions well. ;-)
| >
| > http://www.norcalqrp.org/fcc1.htm
| >
| > Thanks,
| > Don Rasmussen Wb8yqj/6
| > Carlsbad, Ca.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|