TenTec
[Top] [All Lists]

Re: [TenTec] Argosy AMP Connector

To: tentec@contesting.com
Subject: Re: [TenTec] Argosy AMP Connector
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 18 Sep 2006 22:00:59 -0500
List-post: <mailto:tentec@contesting.com>
On Mon, 2006-09-18 at 19:36 -0400, JT Croteau wrote:
> Anyone have a part number for an AMP Mate-N-Loc 4-pin plug used on the
> Argosy and similar rigs of this vintage?
> 
> I need to build a power cable for the Argosy I just purchased as it
> did not come with one.
> 
> Thanks
> 
> --
>  JT Croteau - W6FO - Canton, GA
>  ARS #2,147 | NoGA-QRP | SEDXC | SECC | ARRL

I'm sure its in the archives, because I remember that I posted it a few
years ago. The cost was small from Mouser (www.mouser.com) Another
really good source is Tentec. I've heard of them sending them out
gratis, and you can't beat that price and know for sure they are the
right parts.

I just checked my Corsair II manual and I find that information detail
has escaped.

You need four female pins, a female plug and a cover as I recall. There
are several possibilities in the Mate N Lock family, and I believe they
are interchangeable.
-- 
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>