TenTec
[Top] [All Lists]

Re: [TenTec] Orion freezing up

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion freezing up
From: "Bernhard Hoidn" <bernhard.hoidn@online.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 23 Oct 2006 12:56:45 +0200
List-post: <mailto:tentec@contesting.com>
DL2RBB
Bernhard Hoidn
Landshut
Germany

Hi Danny

I bought in June, 2006 an Orion I V2 with Firmware 2056. A few days later,
the sub RX hanged up. The S-meter was full on the right side and I heard
only noise.
After I turned on the radio a few times, the sub rx worked again.
Than, if I use headphones, after a while I couldn´t hear anything. Also the
speaker is mute.
A new phenomen was last week,   the sub rx hanged up, than I could hear the
audio of the main RX on the audio path of sub RX.  I could turn the  volume
of the Main RX with the Sub RX knob.

My German TenTec Dealer always says, it´s a software problem; now I used
three different firmware and the problems are the same.
That is not  a good  promotion  for TenTec Radios


73

Bernhard
----- Original Message -----
From: "Danny Shaver" <n5nbk@nortexinfo.net>
To: <tentec@contesting.com>
Sent: Monday, October 23, 2006 12:08 AM
Subject: [TenTec] Orion freezing up


> I have an Orion1 running 2.059d. I have not used it mmuch due to work
schedules, but this afternoon I noticed that after a while of operating, the
control panel freezes up. The rig is still working when this happens, I just
cannot change anything since none of the controls work. I performed a master
reset, but it still happens. I turn the rig off and back on, and everything
works fine for a while. Anyone else experience this ? Any ideas ?
>
> Danny N5NBK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>