Whats the signal to wave ratio ??
----- Original Message -----
From: "Dennis, NC2F" <Dennis@NC2F.com>
To: <tentec@contesting.com>
Sent: Sunday, October 29, 2006 8:48 AM
Subject: Re: [TenTec] Vertical radial question
> Vince,
>
> The radiation pattern of your signal can be affected by many factors,
> including radials. In fact, you can take the exact same antenna
> configuration in your yard, and move it to another location (even at the
> same height), and the pattern can change dramatically. The reasons are
> usually related to objects surrounding the path of or signal. As for
> your radials on a vertical, the best advice is to keep them even on all
> side regardless of the total amount used. Always check your antenna with
> an analyzer when adding or taking away radials as your signal to wave
> ratio changes too. It's best to have the SWR low at the antenna, and not
> have to rely on a transmatch to match a high swr. This is also better
> for your radio's finals...
>
> 73,
> Dennis, NC2F
>
> On 10/29/2006 8:38:13 AM, Vince Santis (vsantis@earthlink.net) wrote:
> > Good morning,
> >
> > Does the position of radials on the ground affect the directionality of
> > a vertical. I'm putting up a new vertical and faced with a long narrow
> > lot (50;x30;) as the only practical location for it. All comments and
> > help well be appreciated.
> >
> > TIA,
> > Vince Santis, N1VS
> > Winsted, CT 06098
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|