TenTec
[Top] [All Lists]

Re: [TenTec] Corsair II display problem encountered and repaired

To: kg6tt@arrl.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Corsair II display problem encountered and repaired
From: d.e.warnick@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 05 Nov 2006 17:00:15 +0000
List-post: <mailto:tentec@contesting.com>
Thanks for the info Jerry. It's printed and filed with my Corsair II manuals.

Dave
WA3MKB

-------------- Original message -------------- 
From: Jerry Volpe <kg6tt@arrl.net> 

> Display problem encountered and fixed. 
> 
> Two weeks ago during the CQ WW DX contest I suddenly lost my display on 
> the Corsair II. The internal keyer also ceased functioning as well (the 
> keyer and display are controlled by the same processor). Turning the 
> Corsair off and then on again resulted in a blank display (except for 
> the decimal point). In all other ways the Corsair II worked correctly. 
> Turning the Corsair II off for 20 minutes or more brought the display 
> back to life... for a while. I did notice that it took up to 10 seconds 
> or more from the time the Corsair II was turned on till the display 
> initialized itself. Before its initial malfunction the display always 
> initialized with a second or less. 
> 
> Ad investigation of the display circuit pointed to three suspects... U10 
> the display processor, the 4.05 MHz crystal, and C6 a small electrolytic 
> capacitor that provides a reset pulse on power on. As the frequency 
> display was stable and accurate until the freeze I didn't think the 
> crystal was an issue. The processor was still a suspect but it made 
> sense to check the capacitor first. I removed C6 (connected to pin 28 of 
> U10) and upon testing it I obtained very erratic capacitive readings. I 
> replaced C6 with a known good 2.2uf/50 vdc electrolytic. 
> 
> The Corsair II's display now initializes correctly and shows the 
> operating frequency in about one half a second from power on. Since this 
> repair there have been no further display lock up incidents. 
> 
> Perhaps this may be of value to other Corsair II owners. If your display 
> is initializing more than a few seconds after power on this capacitor is 
> probably changing values and that is a good precursor to the problem I 
> just experienced. 
> 
> 73, 
> 
> Jerry, KG6TT 
> Fairfield, CA 
> 
> -- 
> Ralph Jerald "Jerry" Volpe 
> Amateur Radio Operator KG6TT 
> ARRL Member & VE 
> FISTS 12304 
> 
> 788 Chestnut Drive 
> Fairfield, CA 94533 
> 
> kg6tt@arrl.net 
> 
> 510 325-7724 
> 707 399-8838 FAX 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec@contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>