Ken
Its about 50Hz off on SSB. Seems like a strange problem because, like you
said, they use the same oscillators. The receiver is high. Not sure what to
look at. Rig seems to perform fine in all other respects. Don't want to
adjust anything without knowing what is happening.
Art WA8VSJ
----- Original Message -----
From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, January 13, 2007 10:48 PM
Subject: Re: [TenTec] Omni VI tracking
> Hi Art,
>
> If you are talking about in SSB mode, in theory it cannot be wrong,
> because all of the oscillators in use for TX are the same and have the
> same logical commands applied to them when in RX mode. On the other
> hand, when in CW mode the BFO is switched between 9.000000 MHz for
> receive (same as LSB receive BFO Frequency) and 9.000400 MHz for
> transmit, and the VFO gets different numbers loaded into it, depending
> on the sidetone setting you have selected. The most likely cause of a
> discrepancy between TX and RX frequency would be misalignment of the
> trimmers in the BFO, which is on the TX AUDIO BOARD.
>
> N6KB
>
>
> Art Lewis wrote:
>> I have an Omni VI that works real well, but seems not to be tracking the
>> exmit and rec frequency correctly with my RIT off. I seem to have about a
>> fifty Hz difference. I am using the RIT to correct the problem, but I
>> wonder if there is a simple adjustment I can make.
>>
>> Art WA8VSJ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|