TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI TCXO

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI TCXO
From: "Thomas Jednacz" <tjednacz@ieee.org>
Reply-to: tjednacz@ieee.org,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 21 Jan 2007 14:14:36 -0500
List-post: <mailto:tentec@contesting.com>
Howdy - just did the TCXO upgrade myself. It took longer to get the tools
out and put them away then to do the upgrade. Very simple. Just make sure
that you find the 5 volt supply voltage and don't inadvertently apply 12
volts. Mounts on the side of the chassis easily.
Tom, W7QF

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Steve Hunt
Sent: Sunday, January 21, 2007 1:45 PM
To: tentec@contesting.com
Subject: [TenTec] Omni VI TCXO

My Omni VI has a temperature-controlled oven for crystal oscillator
stability. I believe that on later models TT used a TCXO for better
stability / shorter warm-up time. I know that I can leave my oven powered up
if I want to avoid the warm-up delay, but I would prefer not to have to.

Does anyone know how easy it would be to upgrade to a TCXO? The cost of a
return to TT doesn't warrant the improvement to me, but I wondered if it was
something the competent ham could do at home?

73,
Steve G3TXQ

 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>