TenTec
[Top] [All Lists]

Re: [TenTec] New OII Firmware

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] New OII Firmware
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 26 Apr 2007 22:27:46 -0400
List-post: <mailto:tentec@contesting.com>
It should take about 3 minutes.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "M. K. Hess" <mkhess@frontiernet.net>
To: <tentec@contesting.com>
Sent: Thursday, April 26, 2007 5:15 AM
Subject: [TenTec] New OII Firmware


> Folks,
>
> This is the first time I've done a TenTec reflash. How long should it
take?
> It's been going for 12 hours now, and it's only written 4100 lines of the
> 9700
> that are part of the package. I would suspect that's not normal. I'm using
a
> USB/Serial
> convert cable on a port set for 56K. It's the same connection I use for
> logging, and
> remote control and it works fine for that purpose. Any hints?
>
> Regards, DE Mike, N3EAQ
> www.n3eaq.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>